210 DRAWER SYSTEMS & RUNNERS Ball Bearing Slides Technical Specifications Full Extension Standard Load Class 90kg Installation Instructions A – Align center line of cabinet member to pre-determined center line (H), and place slide 2 mm backward from cabinet opening. Use hole on breather tab for side adjustment (H) Align top of cabinet member to (H) line 2mm Set the cabinet member 2mm back B – Fix the slides through the countersunk holes, and leave the screw loose for final adjustment. Move the slides back and forth, and make sure no screw is bound. C – Align center line of drawer member to the pre determined line (H-6.4 mm), and place drawer member 2 mm backward from the drawer front or the pull-out shelf edge. (H-6.4mm) 2mm D – Fix the drawer member through vertical slots for vertical adjustment. Leave the screw loose for final adjustment. Final Adjustment Try to open and close the drawer to see if slides function correctly. If so, secure the screws and install additional screws as necessary. If not, please make adjustment till slides function correctly. *This instruction is for reference only. It may vary due to different applications. SMETSYS REWARD SRENNUR &