DRAWER SYSTEMS & RUNNERS BALL BEARING SLIDES Technical Specifications PUSH-TO-OPEN FULL EXTENSION PUSH-TO-OPEN LOAD CLASS 45KG C – Please refer to the following drawings for the drawer member and cabinet member mounting position. USE FOR MANUAL DRILLING Place drawer member Set cabinet member flush against drawer front. with cabinet opening. *Set drawer member back by 3mm when using a bumper. USE FOR PROGRAMMED DRILLING (32MM SYSTEM) 5mm 37mm Use 1st hole 37mm far from the Set drawer member back by 5mm edge to fix the cabinet member *Set drawer member back by 8mm when using a bumper. 7mm D – The actuating stroke of Repon touch to open is 4mm, so please reserve at least 10mm gap between the drawer back and cabinet back. E – The new touch to open deliberately set the drawer member above the cabinet member by 6mm in fully closed position to absorb installation tolerance. 6mm F – Please refer to the following drawings for the drawer member and cabinet member mounting position. Place drawer member against drawer front D D = Drawer front thickness + 6mm *This instruction is for reference only. It may vary due to different applications. www.nover.com.au 161 & RUNNERSDRAWER SYSTEMS 10mm