HINGES & LIFT FITTINGS 555 2. DISTANCE TO THE EDGE (B) This is the distance from the 35mm cup hole to the door edge. This value is variable according to the margins for each type of hinge. These margins are specified on the hinge diagrams in the catalogue. B 3. CUP DRILLING DEPTH (H) This is the minimum required dril ling depth for a hinge Cup. Depending on the hinge, this value may be 10.5 or 12.5mm. 4. LATERAL DOOR DISPLACEMENT (F) The front-side corner of the door has a slight lateral displacement. This displacement must be respected in order to open the door. Main factors affecting this displacement are door thickness (g) and distance to the edge (b). See charts in every case. F B 5. HEIGHT OF THE PLATE These are the different heights of the mounting plates in order to correctly overlay the door on the side. 6. REQUIRED NUMBER OF HINGES & HOW TO ARRANGE mm. THEM ON THE DOOR 2500 The number of hinges required depends on several factors, including the type of hinge, the door’s weight, height and width, etc. For this reason, and given the 2000 number of variables, please check the charts for an estimate (next to the diagrams in the catalogue). You are advised to place the upper and lower hinges at least 1500 80mm from the edges. When dealing with low or particularly wide doors, the distance to the edges must be reduced as much as possible. Main factors are door 1000 width and weight. See diagram pictured on the right, for every hinge later. It is advised to locate upper and lower hinge at less than 80mm from each edge. 500 LIFT FITTINGSHINGES & HG